Page 472 - Demo

442Dimensions in millimeters (inch) unless otherwise statedACTUAL SIZEACTUAL SIZE8285D8D9D1D4D5D7NY82 DZUS® Lion Quarter-Turn FastenersReceptacles · Self-clinchingwww.southco.com/82Material and FinishSteel, zinc plated and stainless steelInstallation NotesPress receptacle flush to frameNotesReceptacle shown installed flush to the frame. To eliminate the gap between the frame and outer panel, install to a depth ≥ the thickness of the selected retainer. This depth should be added to the TMT.Ultrasonic For ThermoplasticsØ 11.81(.465)10.29(.405)Ø 13.4(.53)OverknurlLocking stops1.57 (.062)0.30 (.012)11.2(.44)2.5±0.1(.100±.005)Optional alignment lug4.8(.19)Min. Ø 11.9(.469 +.003-.000+0.09-.0.00)Min.Ø 11.9(.469 +.003-.000+0.09-.0.00)Alignment lug0.30 (.012)11.2(.44)2.5±0.1(.100±.005)Optional alignment lug4.8(.19)Min. Ø 11.9(.469 +.003-.000+0.09-.0.00)Min.Ø 11.9(.469 +.003-.000+0.09-.0.00)Alignment lugShielded – Self-ClinchingTMT = P - 0.5 (.020) TMT = P + (Retainer adjustment value) - 0.5 (.020)TMTTMTP PPart NumberSee tableNotesUtilize stud selection column indicated when choosing a stud length from the stud length table on page 437Material and FinishSteel, zinc plated and stainless steelInstallation NotesFor use in low carbon steels, aluminum and stainless steels in the annealed condition that are RB85 or softerSee page 627 for installation guidelinesFrame thickness (F) > 0.9 (.036) + Retainer thickness: TMT = P + F Frame thickness (F) ≤ 0.9 (.036) + Retainer thickness:TMT = P + 0.9 (.036) + Retainer thickness F FPPTMT TMTTMT = P + F (when gap is > retainer thickness)Gap13.7±0.3(.540±.010)12.7±0.3(.500±.010)ReceptaclehousingTwo orientation marks (wing or slot) of studwill be 900 from these marks when fastened0.9±0.1(.036±.005)(.435+0.0-0.4+.001-.004 )11This hole muststay sharp. Donot chamfer.Frame0.94 (.037) Min.+.003-.000+0.1-0.0)Ø(.43711.112(.465)Blind Hole Installation Thru Hole InstallationPart Number Stud Selection Column 82-35-310-55 BPart Number Stud Selection Column 82-35-315-55 CPart NumberSee tableNotesUtilize stud selection column indicated when choosing a stud length from the stud length table on page 437Installation